86AF Fibered Trowel Mastic


Karnak #86AF Fibered Trowel Mastic is manufactured from a blend of selected asphalts, fibers, stabilizers, fillers and solvents. Karnak #86AF Fibered Trowel Mastic is a heavy bodied product which dries to a tough, flexible and elastic protective coating. Karnak #86AF Fibered Trowel Mastic is highly resistant to the penetration of water and moisture over a wide range of temperature and service conditions. Karnak #86AF Fibered Trowel Mastic has excellent resistance to most acid, alkali, and salt spray solutions.







USES


Karnak #86AF Fibered Trowel Mastic is especially recommended for application as a protective coating for exterior masonry walls below grade and exterior face of interior walls (cavity wall construction), and as a dampproofing product for retaining walls, bridge abutments and steel panels. It is also used for the coating of interior faces of exterior masonry walls above grade, and for all back-up material for masonry, such as stone, brick or concrete. Karnak #86AF Fibered Trowel Mastic can be used for waterproofing when used in conjunction with a multi-membrane application.

SPECIFICATION


  • ASTM D-4586 Type I, (Non-)
  • Fed Spec #SS-C-153 Type I (except -Free)

SURFACE PREPARATION


Surfaces must be clean, dry and free from oil, grease, release agents, laitance, dirt, dust and debris. All cracks and holes should be filled with Karnak #86AF Fibered Trowel Mastic prior to surface coating. If the surface is porous, it is recommended that Karnak #108 Asphalt Primer be utilized to provide a firm film base prior to application of Karnak #86AF Fibered Trowel Mastic.

APPLICATION


Karnak #86AF Fibered Trowel Mastic is easily applied with a regular trowel. Using even strokes, a smooth uniform film can be obtained and provide adequate protection. Coating should be continuous and free of pinholes or holidays. Allow the film to cure for at least 24 to 48 hours prior to backfilling. Cure time can be affected by the film thickness and the temperature. Care should be taken during backfilling, so as not to puncture or damage the coating. A protection board is highly recommended to protect the film when backfilling. Backfilling should take place within 7 days.

COVERAGE RATE


A recommended coverage rate of 5 to 6 gallons per 100 square feet is desired for adequate protection. Application rates can vary depending upon the surface to be covered.

CARE OF TOOLS


Tools and other equipment should be thoroughly cleaned with mineral spirits, taking necessary precautions when handling combustible materials.

PHYSICAL PROPERTIES


  • Weight per Gallon: 9.2
  • Solids by Weight: 59%
  • Solids by Volume: 56%
  • Color: Black
  • Permeability: 0.5 mg. per sq. cm.
  • Cure Time: 24 to 48 hours @ 77° 50% Relative Humidity
  • Cured Temperature Range: 0°F to 180°F

CAUTION


Do not use near open flame. Avoid breathing solvent and fumes and avoid prolonged contact with skin. Do not take internally. If swallowed, do not induce vomiting. Call a physician immediately. Keep out of reach of children. Keep container covered when not in use. Do not thin. Dispose of in an environmentally safe manner.

PACKAGING


Available in 5 gallon palls and 55 gallon drums.

Translate Site

Kanopy Reflective Roof Maintenance Solutions
  • Reduce Energy Use
  • Lowers Peak Energy Use, reducing energy costs year-round
  • Helps the environment, reduces "Heat Island Effect"
  • Extend the life of the roof
  • Reduces waste. Helps avoid roof tear-off.
  • Economic compared to roof replacement
  • Eliminates interior building operation disruption